Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Gate Installation for Spring Valley Homeowners
A new gate is one of those projects where the wrong install shows up fast: a post set shallow in our caliche-hard soil, a slab-mounted operator that floods in a monsoon, a driveway swing that clears by half an inch until the slab heaves in July. We install driveway, pedestrian, sliding, swing, double and security gates across Spring Valley, and we build them for the way this valley actually behaves. Our technicians have up to 25 years of experience, and every job carries the 90-Day Done Right Promise in writing: if something isn’t right, one call brings us back. Call (888) 300-3906 and a live person answers, day or night, to set up your free measure.

What Our Gate Installation Service Includes
An install is never just the gate. It’s the footings, the hinges, the operator, the power and the safety edges working together, and it’s the part most people never see that determines whether the gate is still square in five years. Here’s what each type of install involves and who it’s for.
Driveway Gate
A driveway gate is the big one: the entrance to your property, and the piece people judge the whole house by. You need one when a wooden gate has rotted at the base, a metal gate has bowed from a vehicle strike, or you’re fencing the front for the first time and want the driveway to close. We set posts at the depth the soil and gate weight call for, hang the gate so it latches without a lift, and line the operator up so it travels full swing without binding.

Pedestrian Gate
A pedestrian gate is the walk-through gate at the side of the house or beside the driveway, sized for people rather than cars. You need one replaced when the hinges have sagged the gate into the ground, the latch no longer lines up, or the pickets have rusted through where the sprinklers hit them. We hang pedestrian gates to clear the ground evenly with a latch that catches on the first push, and we match the style to what’s already on the property.

Sliding Gate
A sliding gate runs on a track or cantilever system instead of swinging out, so it’s the right choice where the driveway is short and a swing would block the street or a slope. You need one when a driveway is too tight for a swing gate, or an old slider has jumped its track for the last time. We level the track or set the cantilever foundation to spec, so the gate glides instead of dragging, and we check the operator against the gate weight before we call it done.

Swing Gate
A swing gate hinges on posts and opens inward or outward, and it’s the classic choice for most residential driveways. You need one when the posts have shifted, the gate binds halfway through its arc, or you want a new gate that swings cleanly with an automatic operator. We check the hinge posts first, because a gate sags in the hinge post, not in the middle, and that’s where we start every swing gate install.
Double Gate
A double gate is two leaves meeting in the middle, which is what you use for wide driveways, RV pads and equipment access. You need one when a single gate can’t span the opening without a wheel or a huge operator, or when you want a wide driveway to open for trailers and close tight for everyday. We build the two leaves to meet with an even gap and set the drop rod and latch so neither side sags over time.
Security Gate
A security gate is an entry gate tied to access control: a keypad, a card reader, a phone app or a call box, so only the people you want come through. You need one when you’re gating a side yard, a shop entrance or a rental property and want an actual record of who comes and goes. We install the gate and the access hardware as one job, test every entry method, and walk you through it before we leave.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Brands We Service for Gate Installation
We install and service operators from BFT, Linear, Viking, Ghost Controls, LiftMaster, FAAC, DoorKing, Elite and Mighty Mule. Each one has its own habits. BFT operators are solid units but the control board is where trouble shows up after a few summers of heat, so we set them with ventilation and shade in mind. Linear is common on residential driveways and works well when the arm is mounted square and the limits are set right, which is where we start. Ghost Controls is a favorite for rural and solar setups, and we know how to size the panel and battery so the gate still cycles in December.
We’ve been working on these brands long enough to know where each one wears out, and that matters more on installation than most people realize. The right operator matched to the right gate weight and the right power setup is half the job. Whether you have Viking, FAAC, Mighty Mule or any other make, we can help.
Signs You Need Gate Installation Right Now
- The gate drags or won’t latch. When a gate scrapes the ground or the latch misses, the hinge post has usually moved or the gate has warped past saving. Left alone, the operator keeps pushing against the drag and wears out faster.
- The posts are leaning or rotted. A leaning post in Spring Valley usually means water got to the footing. New panels on a bad post will fail, so the post comes first.
- Rust through the frame or pickets. Once rust eats through the tube or picket, welding a patch only buys a season or two. A new gate is often the cheaper call over repeated repairs.
- The gate is too narrow for your vehicles. If your truck or trailer clears by a few inches, it’s only a matter of time before a mirror or a fender pays for it. Widening the opening is a real install, not a patch.
- You have no way to control who comes through. An open side yard or an ungated drive with no lock, keypad or call box is a security gap. A security gate with access control closes it in one job.
Our Gate Installation Process – Step by Step
- 1
Free measure and site check. We come out, measure the opening, check the soil and slope, and look at where power is and where the gate will travel. You get a written price before anything is ordered, and that price doesn’t change at the door.
- 2
Choosing the gate and operator. We match the gate style and weight to the operator and the power setup: line voltage, low voltage or solar, depending on the site. You’ll know what’s being installed and why before the order goes in.
- 3
Setting posts and footings. Posts go in at the depth and footing the gate calls for, not a guess. We check plumb and square with a level and a string line, because a gate set out of square is a gate that fights you for its whole life.
- 4
Hanging the gate and mounting the operator. We hang the gate so it swings free on its hinges, then mount the operator and set the open and close limits so it stops where it should. Safety edges and photo eyes get wired and tested here, not after.
- 5
Test, walkthrough and the promise. We cycle the gate through a full open and close, test every access method, and walk you through the operation and the manual release. Then you get the 90-Day Done Right Promise in writing, and one call brings us back if something isn’t right.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Installation Cost in Spring Valley?
A typical pedestrian gate install in Spring Valley runs $1,200-$2,800 depending on material and whether you add an operator. A single swing driveway gate with power and an operator usually runs $3,500-$7,500, and a double driveway gate with an operator and access control runs $7,000-$15,000 or more for wide spans. Sliding gates run in a similar range to swing gates, with the track or cantilever foundation adding to the job.

What affects the price most: the gate material (steel and ornamental cost more than wood or chain link), the span and weight, whether you need a new footing or slab work, the operator brand and power setup, and whether access control gets tied in. To avoid overpaying, get a written, line-item price before you order anything, ask what’s included for the operator and safety edges, and don’t let anyone talk you into a full replacement if the posts and operator are still sound. We give a free second opinion on any written estimate, so you can compare ours to another without pressure.
Every estimate from us is free and itemized, and the price we quote is the price you pay. We don’t change it at the door. Our standing offers apply too: $40 off any repair over $200, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. Call (888) 300-3906 for an exact quote on your Spring Valley install.
Gate Installation Near Spring Valley – Our Service Area
We install gates across Spring Valley and the surrounding communities, including Summerlin, Enterprise, Paradise, Winchester, Whitney, Sunrise Manor, Henderson, North Las Vegas, Boulder City and Sandy Valley. Response times depend on the day and the job, but most Spring Valley addresses get a measure within a few days of your call. If you want a look at how we handle nearby installs, see Gate Installation in Summerlin and Gate Installation in Enterprise.
Serving Spring Valley, NV – Our Local Coverage Area
We serve Spring Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Gate Installation in Spring Valley
Gate installation is the full job of setting posts and footings, hanging the gate, mounting and programming the operator if there is one, and wiring the safety edges and access control so the gate opens, closes and locks the way it should. It’s more than dropping a gate into an existing opening. It’s making sure the posts, the gate, the operator and the power all fit together, which is why we measure and price the whole job before anything is ordered.
Most single residential gate installs take one to two days on site once the gate and operator are in hand. Double gates, sliding gates and jobs with new footing or power work can run two to four days. From your call to completion, plan on a couple of weeks in most cases, because the gate is measured and ordered to your opening. We’ll give you a realistic schedule at the estimate, and we show up in the window we promise.
Pedestrian gates typically run $1,200-$2,800, single swing driveways with an operator $3,500-$7,500, and double driveway gates with an operator and access control $7,000-$15,000 or more depending on span and material. The biggest factors are gate material, span, footing and power work, and the operator brand. Every estimate is free and written, and the price we quote is what you pay when the work starts. Call (888) 300-3906 for an exact quote.
Yes. We install and service BFT, Linear, Viking and Ghost Controls, along with LiftMaster, FAAC, DoorKing, Elite and Mighty Mule. Knowing how each brand is mounted and programmed means fewer surprises after the first summer of heat. We’ll tell you which operator fits your gate and your power setup, and we won’t sell you one you don’t need.
We answer the phone 24 hours a day, seven days a week, and we can get out to look at an urgent gate problem fast. Full new installations are measured and scheduled, so they’re set up as planned jobs rather than a same-day emergency. If your gate is stuck open, off its track or not secure, call (888) 300-3906 and we’ll sort out the fastest path to fixing it.
Every install carries the 90-Day Done Right Promise in writing. If anything we installed doesn’t work the way it should within that window, one call brings us back and we make it right. It’s stated plainly, not buried in fine print, and it’s the same promise on every job we do.
Clear the driveway and the gate opening of vehicles, trash cans and anything that blocks access, and make sure we can reach the power source. If you have HOA rules about gate style or color, have those in hand at the measure so the gate is ordered to spec the first time. Beyond that, there’s nothing to do: we handle the rest, and we’ll walk you through the finished gate before we leave.
Schedule Your Gate Installation Service in Spring Valley Today
If you’re ready to gate your property the right way, call (888) 300-3906. A live person answers around the clock, and we’ll set up a free measure and a written, no-obligation estimate. You’ll know the price before any work starts, and your install comes with the 90-Day Done Right Promise in writing. We’d be glad to earn your business. For other gate work, see our Gate Repair, Gate Motor & Opener, Gate Access Control and Gate Parts & Welding pages, or start at our home page.
Written by the team at Gatewood Fence & Gate Spring Valley.